Bathroom Countertop Remodel

Bathroom Countertop Remodel

 

Sixteen years and we finally, finally, finally changed up our kids bathroom!

It’s about time!

I spent a long time trying to find ideas that we could afford and that would be durable for the boys. I decided an industrial concrete look would be the perfect fit.

  • It takes a lot to destroy and can withstand the test of boys
  • It’s fairly inexpensive
  • Looked easy to do
  • Looks industrial with a touch of elegance.

I got my inspiration from all these really cool concrete countertops on Pinterest.

We had the cheap cultured marble countertops with integral sinks and hardly any money to work with.

 

I did a lot of research and found that with the correct prep, Henry’s Feather Finish would do the job I was looking for.

 

  • Remove your faucets and drain stoppers.
  • Use the electric sander to sand all of the countertops. We made sure we got the ledge and I hand sanded the corners where it is really hard to clean. I want to make sure the concrete sticks to that. (The sink on the right has not been sanded that was just sixteen years of use…ewww)
  • Replace your drain plate.

Make sure to sand it to a dull finish. The rougher the better.

 

 

  • Mix the Henry’s Feather Finish in your chosen container. I just added a cup or two and then added water, mixing it until it was a pudding consistency. I ended up using my hand beater and mixed with an empty protein shake canister and then transferred it into my metal drywall mud pan.
  • Then with the trowel, I applied a fine layer of mud on the counter. It does not need to be thick. There will be layer upon layer applied.
  • Don’t forget to apply on the backsplash.
  • I applied the mud in the sink with gloved hands. I felt like I was sculpting. It doesn’t look good at first but layer after layer it looks better.
  • I also used my fingers to apply to the edges and corners.
  • It took about 20 min. to dry and then I applied another layer. I think I applied approx five thinner layers.
  • After each layer dried a few minutes, approx 10-15 min. I lightly wet my hands and smoothed every nook and cranny to my liking. You want the concrete to be slightly firm but not to hard. If you have too much water on your hands you will wipe concrete off and if it’s too dry you might just have to lightly sand some ridges.

We used the cups to measure equal powder to equal water and then we ended up using our hand mixer to mix the product.

  • Once I got it the way I liked I allowed it to dry overnight and then gave it a light hand sanding.
  • I then sealed it with  High Gloss Sealer protective sealer wet look… just because we already had it. I just painted it on.
  • I wanted a super shiny look so I painted about fifteen layers of sealer on it.  After all I have boys and I have to make this sucker look good for a long time. 🙂
  • After it dries set your faucet.

I finished my cabinet makeover painting the base with Lowes Sherwin Williams Federate Blue satin paint, made up to be 80% lighter.

I can’t believe I hadn’t done this sooner. It is BEAUTIFUL and was so EASY!

 

Share this post

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Start typing and press Enter to search

Shopping Cart

No products in the cart.

error: Content is protected !!